Alu GT Lobo

The DH is to go on the LTS1.
The LTS has the Boxxer on it and is my daily rider so I can't take it off until I have a replacement. ;)
Boxxer is too new for the LTS anyway...

263618_10150289591542419_705422418_9769824_775736_n.jpg
 
looking good , what are you doing with the frame , paint or polish.
If your after old school parts i have a few

hope m4 brakes silver with the black newer levers and braided hoses and aztec rotors.

Red x-lite top cap

front 20mm razor rock racing hub 6 bolt disc

rear woodman bill exteme disc hub 10mm solid axle very stiff

both have had new bearings

First refussel before i create a thread buddy
 
ramstein-dh":dtnf5f5v said:
looking good , what are you doing with the frame , paint or polish.
If your after old school parts i have a few

hope m4 brakes silver with the black newer levers and braided hoses and aztec rotors.

front 20mm razor rock racing hub 6 bolt disc

First refussel before i create a thread buddy

Hope M4's would be sweet, but I'm not sure they'd fit on the rear mount.
What's a Razor Rock hub look like? Will need one of them at some point.

I'm getting it powdercoated black. ;)
 
jimmy5willy":2xmrzi3z said:
ramstein-dh":2xmrzi3z said:
looking good , what are you doing with the frame , paint or polish.
If your after old school parts i have a few

hope m4 brakes silver with the black newer levers and braided hoses and aztec rotors.

front 20mm razor rock racing hub 6 bolt disc

First refussel before i create a thread buddy

Hope M4's would be sweet, but I'm not sure they'd fit on the rear mount.
What's a Razor Rock hub look like? Will need one of them at some point.

I'm getting it powdercoated black. ;)

Black sounds real good , were are you based?
Reason i ask is , i can get full frames done for £30.00 with amazing results.
Well Razor rock hubs are very nice and massive compared to hope.
I will get some pics for you.
Yes i see what you mean about the rear brake.
I had the same version in your pick on a specialized fsr elite.
It goes on the rear hub and the rod connected to the v brake boss.
I'm sure they need special hubs though , or a modified hub , as when you use a normal hub , it measures more than 135mm spacing.
Shame as mine have braided hose and loads of spares.
Non the less i will get pic for you to look over.
I also have boxxer adaptors for the m4 .
Good luck with the build

Jason
 
I've been quoted £35+vat for everything right here in Soton, so it would work out the same as posting it up to you anyway.
logo.jpg


Cheers though. :cool:


And the hub in the photo has the special short axle. Noo worrrrries :p
 
$(KGrHqQOKjoE4kCP!ZeOBORUp9k3BQ~~0_12.JPG


c03d9fe8.jpg


My postchick is gonna hate me this week.... :oops:

Spec sheet is also up now (at the start) Slowly filling in the gaps.... :cool:
 
Back
Top