Norco Torrent. Tweaked 13.1.13

When I had a 20mm front end I used a Hayes 20mm, 203mm adaptor. It's about twice as thick as a normal adaptor. Post Mount only though.
Are you going to run a chain device? Just asking as I may have something for you ;) Is it a BB mount or do you have an iscg mount?
 
.

BB mount please, i have been on the lookout for a dmr chaincage.
They seem to hold there value though :? not that they are expensive :D
 
erm so you sorted steerer length problems then? just?

i normally have problems with the rear caliper on my frames, generally need 1-2mm of spacing :?

oooo xizang, what you got for him?!
 
.

Alas the steerer isn't sorted yet :?
One the downfalls of bank holidays is i'm not in work to do my tinkering :D
I do however have a section of steerer on the way so should be sorted soon ;)
 
This:

DMRSpeedguideElite1.jpg


DMRSpeedguideElite2.jpg


Now, it does need a bottom roller but any chainguide roller will be ok (I expect someone on here will have one if you ask). And the seat-tube clamp is missing (same goes for this or buy a new one for £3.99 http://www.chainreactioncycles.com/Mode ... odelID=745 ).

As for price, I'll pm you ;)
 
if gg doesnt want it i would like to be considered for it, thought it was more hassle than that to get it running
can it go with bash though?
 
cyfa2809":17gvvnuo said:
the a-c on the forks i think you have just got away with
Judging by the angle of the chainstays i'd say its about smack on :D how the hell i managed that i don't know ;)
 
Back
Top