Kona-853 Retro Guru Feedback View Apr 14, 2011 #1 Hi all I see the tool to tighten/loosen the center lock disc brakes is the TL-LR15. I have a TL-HG15 tool will that work to a good standard or is it a bit of a bodge. Many Thx
Hi all I see the tool to tighten/loosen the center lock disc brakes is the TL-LR15. I have a TL-HG15 tool will that work to a good standard or is it a bit of a bodge. Many Thx
letmetalktomark Retrobike Rider Gold Trader Feedback View Apr 14, 2011 #2 Should be fine. I have used my std cassette tool for centre locks with no problems. Just make sure the splines engage correctly and fully.
Should be fine. I have used my std cassette tool for centre locks with no problems. Just make sure the splines engage correctly and fully.
Khane Gold Trader Feedback View Apr 14, 2011 #3 my old shimano lockring tool was no where near long enough or with a big enough internals to be able to get it to fit over the axle. so bought an icetools one with centre pin so as not to screw things up http://cgi.ebay.co.uk/New-Ice-Toolz-Cas ... 230fcd05fc quite well made too. When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
my old shimano lockring tool was no where near long enough or with a big enough internals to be able to get it to fit over the axle. so bought an icetools one with centre pin so as not to screw things up http://cgi.ebay.co.uk/New-Ice-Toolz-Cas ... 230fcd05fc quite well made too.