Marin Mount Vision Pro (frame only at this stage)
- Thread starter Jacqueslemac
- Start date
Cocktail_Dave
Retro Guru
nice looking frame , looking forward to seeing the uild up 
Jacqueslemac
Dirt Disciple
Brilliant. Right, now who's going to sell me a pair of forks?
Best I get trawling the For Sale section!
Best I get trawling the For Sale section!
hmm
http://www.retrobike.co.uk/forum/viewtopic.php?t=136463
reckon these will be too short going by your measurements though :roll:
http://www.retrobike.co.uk/forum/viewtopic.php?t=136463
reckon these will be too short going by your measurements though :roll:
Jacqueslemac
Dirt Disciple
Afraid so, but thanks for the tip off.
Nice frame!
Some advice - try and stick to 80mm forks as they maintain the geometry and feel of the bike.
Also, I'd hunt a set of the Manitous out for it.
As for the front mech comments - it should be an XTR M952 bottom pull with the lower mount position. I actually have the exact one for sale in my thread currently.
Some advice - try and stick to 80mm forks as they maintain the geometry and feel of the bike.
Also, I'd hunt a set of the Manitous out for it.
As for the front mech comments - it should be an XTR M952 bottom pull with the lower mount position. I actually have the exact one for sale in my thread currently.
