What size canti stud for Fox Float 80RL

Carl, I might have some lying around, but will have to check that. Got a little bag of goods with this frame

http://www.konabikes.co.uk/2k7bikes/kul ... me_2k7.php

and quite sure I remember there being canti studs. They would have been for the Reba fork, but should fit the RL80 with modern industry standards and all. Give me a couple of days to dig around then write me in case it slips my mind ;-)
 
Carl, I might have some lying around, but will have to check that. Got a little bag of goods with this frame

http://www.konabikes.co.uk/2k7bikes/kul ... me_2k7.php

and quite sure I remember there being canti studs. They would have been for the SID fork, but should fit the RL80 with modern industry standards and all. Give me a couple of days to dig around then write me in case it slips my mind ;-)

PS my buddy who I ride with weekly has some RL100's at home with canti bosses, so I can try my studs there on tuesday when I go over for dinner. If they fit his, they fit your's.
 
Thanks Paul...much appreciated. I am using ones from my old Manitou Mars forks at the moment....and whilst they work they don't 'fit' into the forks as they are missing a broader 'washer' bit :?
That doesn't make sense does it.
I'll give mojo a call in the morning
All the best
Carl
 
I found my studs already. That was fast. Should I check if they fit his RL 100's? If so we can make a pretty good guess they'll fit your forks and I can send them off to you the next day. If it turns out they are wrong, no harm done.
 
Back
Top