Hiya, I'm looking at new m*%&rn frames and want the Geometry right this time, On my 2004 White Bros DT1.2 forks I flipped a widget inside to take travel from 120mm to 100 as its meant to but still at 490mm long (axle to crown, they are still upto 20mm too long for one of the propsed new frames. How would you go about lowering em? or is this unadvisable?
My ideas so far
getting a similar size spring but shorter from 'somewhere'
Chopping the rod
Or should i just presume the 10-20mm rider loaded sag is enough
See I am retro, the second forks I have owned these!