Re:
That was indeed quite a set-back yesterday. But no ways a "give up" situation.
Thank you syncrosfan, for your information. I will sure sure look into both option.
Actually, I was also thinking of machining down the interfaces on the frame. But I have to take some measurements first,
to see if this is feasible. The other thing that I will have to consider when doing so, is the outer diameter difference on the 2 connecting tubes
(main frame and carbon tube). If the difference is minute, it might work. If it is to obvious, I might want to consider the modified full carbon tubing.
Either way, it is going to be a challenge. Let's get at her ;-)
Cheers
Jeroen