hopefully have more luck in here:
got a DMR revolver rear hub that i'm servicing.
the cone nut on one side is quite pitted making it roll a bit rough.
can i sand this back with fine grade and polishing compound - or will this affect the bearing race too much?
or is there a source to get a replacement?
pitted cone nut:
the worst bit:
plus the axle is 10mm diameter.
>Specialized FSR Elite '99: viewtopic.php?t=173952&highlight=
>Diamondback Apex build: viewtopic.php?f=6&t=320993
>FSR frame bearing upgrade project: viewtopic.php?f=41&t=288979
"Happy is my last goal"