WTD- suntour cyclone front mech- for TA cranks

mellon farmer · Sep 4, 2015

I recently purchased some lovely TA cranks and have been reading I will need a Suntour Cyclone front mech due to the straight arms and lack of clearance.

28.6 clamp would be great, for a steel frame with 27.2 seat post.

If any other recommendations please get intouch

daccordimark · Sep 4, 2015

You can use any front mech with a non-lipped leading edge so most older ones will do. Suntour are a good bet because if nothing else they're much cheaper than old Campag ones and just as good if not better. I don't think I have anything suitable at the moment but I'll have a look.

Mark.

mellon farmer · Sep 5, 2015

thanks Mark- annoyingly I had a TA with Suntour touring set up on a Holdsworth that was I sold as too small a few years back.

walkmanman · Sep 5, 2015

WTD- suntour cyclone front mech- for TA cranks

mellon farmer

Retro Guru

daccordimark

Senior Retro Guru

mellon farmer

Retro Guru

walkmanman

Senior Retro Guru

Similar threads

Latest posts