WTD - Gear lever mounting bracket for early Profile tri-bars

Old Ned

Old School Grand Master
I have a pair of the early design Profile Tri-bars with the 'all-in-one' bar section and I believe they made a bracket to fit at the 'pointed end' for mounting gear levers. There is a hole which is probably intended for this to fit.

Anybody got one?

For my Buzz lo-pro.
 
pondlife":1yumriwm said:
i have one, i have no need for it any longer. but can i find it?
i'll get back to you.

Thanks for that. I look forward to your (positive) reply :)
 
Old Ned":320k9z24 said:
pondlife":320k9z24 said:
i have one, i have no need for it any longer. but can i find it?
i'll get back to you.

Thanks for that. I look forward to your (positive) reply :)

Any news at all? Have you been able to find it?

Bike is now complete except for this.
 
i think i may have had what your looking for, i sold some shifters to GordanB on this forum week ago and sent the bracket to hold the shifters together in the post :LOL:
I doubt he needed the bracket as he was attaching the shifters to the downtube
Drop him a pm!
 
5Bulll":ui3urz5q said:
i think i may have had what your looking for, i sold some shifters to GordanB on this forum week ago and sent the bracket to hold the shifters together in the post :LOL:
I doubt he needed the bracket as he was attaching the shifters to the downtube
Drop him a pm!

Thanks for the tip!
 
pondlife":2qx70iv1 said:
Hey Ned
i've found it, don't suppose you still need it?
Now that is decidedly weird. After all this time I was only thinking about it this morning! I was considering what bike I may ride in some 10's this season and remembered I still didn't have the tri-bar gear levers.

So, assuming it's the correct one for the bars that I have, how much?
 
Back
Top