Campag C Record Gear Lever Washers

rusty bodie

Senior Retro Guru
Feedback
View
Does anyone have a couple of these brass washers for the old retrofriction levers they can sell me?



Thanks,

Craig
 
I bought some washers to do the exact same job, they do need a wee fettling on the ID?

But they worked perfectly, if you're interested i'll 'mic' them up for comparison.

Carl.
 
3? 1 for each side and 1 to practice on?

I'll rummage through the parts bins and 'mic' one up...later tonight.

PM me your address.
 
Measurements are in mm:-

Original, OD 15.94, ID 9.18, thickness 0.52. Middle.

Number 1. OD 16.72, ID 8.58, thickness 0.97. Left.
Number 2. OD 15.70, ID 8.46, thickness 1.47. Right

Both fit inside the lever but need the ID fettling.
 

Attachments

  • Washers.jpg
    Washers.jpg
    120.3 KB · Views: 361
Back
Top