Team Marin
- Thread starter Lhatch4
- Start date
takeawaydave
Dirt Disciple
Yeah nice frame these were the top spec'd frames from the range. Condition looks good and decals are intact 
If you check the serial number (under side of crank) you should be able to learn what year its from.
If you check the serial number (under side of crank) you should be able to learn what year its from.
MarinMartin
Marin Fan
Lhatch4
Fat Chance Fan
Re:
It looks better in the picture. There is a small dent in the top tube and lots of chips and scratches. I removed the headset and derailleur and gave it a bath. I've sorted most of the parts. I have a manitou fork that I planned to use but the steerer tube is too short. I also need a rear wheel.
It looks better in the picture. There is a small dent in the top tube and lots of chips and scratches. I removed the headset and derailleur and gave it a bath. I've sorted most of the parts. I have a manitou fork that I planned to use but the steerer tube is too short. I also need a rear wheel.
Lhatch4
Fat Chance Fan
Re:
I started putting this thing together. The fork is a place holder. There steerer tube is about a half inch too short. I haven't found a suitable replacement yet. I also got an email after putting the brakes on that these Avid Single Digit 7's have been recalled. I need to figure out how to get them replaced. This ,unfortunately, is a slow moving project. I was hoping to get some rides in on this bike before the snow starts falling but I think this might be my winter project now.
I started putting this thing together. The fork is a place holder. There steerer tube is about a half inch too short. I haven't found a suitable replacement yet. I also got an email after putting the brakes on that these Avid Single Digit 7's have been recalled. I need to figure out how to get them replaced. This ,unfortunately, is a slow moving project. I was hoping to get some rides in on this bike before the snow starts falling but I think this might be my winter project now.
