Was trying to re-fit my Headshoks to my Flash frame this morning after changing the headset bearings. All the information I've seen says just TWAT the bottom of the forks to drive the race into the frame. I wasn't overly happy doing this but out came the rubber mallet. Bang! Bang! Tsssshhhh! Sh1t! I hit the air valve and cracked the air cap underneath. I have managed to buy a new one. But is it possible to do myself or am I going to be better off sending the forks to TFTuned or someone?
How do I fit the forks as well without killing them? TFTuned bloke said to install the stem and hit that to pull the lower bearing race into the frame and on the forks.
How do I fit the forks as well without killing them? TFTuned bloke said to install the stem and hit that to pull the lower bearing race into the frame and on the forks.