got a DMR revolver axle that i'm servicing.
the cone nut on one side is quitepitted making it roll a bit rough.
can i sand this back with fine grade and polishing compound?
or is there a source to get a replacement?
pitted cone nut:
the worst bit:
the size:
plus the axle is 10mm diameter.
the cone nut on one side is quitepitted making it roll a bit rough.
can i sand this back with fine grade and polishing compound?
or is there a source to get a replacement?
pitted cone nut:
the worst bit:
the size:
plus the axle is 10mm diameter.