Retrobike Forum Index

It is currently Fri Oct 28, 2016 5:24 pm

* Login   * Register * Search  * FAQ

Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat May 19, 2012 4:50 pm 
Temporary Ban
Temporary Ban

Joined: Mon Jun 21, 2010 10:25 pm
Posts: 339
Location: lIVERPPOL
Just wondering how you guage the 5nm torque by hand?
I don't have a torque wrench.

Also should the gap close completley?

it tighten either one at a time bit by bit but when i tighten one the other goes loose and so on
and they never actually fully tighten until the gap closes on the lowers?

 Post subject:
PostPosted: Wed May 23, 2012 10:46 pm 
Dirt Disciple

Joined: Tue Mar 27, 2012 7:55 pm
Posts: 10
Location: Bracknell
I had a set of 888 and to torque them up I used a park tool milti allen key set held like a screw driver. This applied a very small amount torque. If you only have single Allen keys use the small arm of the Allen key to torque load, this keeps the loading small. The gap would nearly be closed up. It is. Very similar to the shimano hollow tech 2 cranks pitch bolts, just a bit at a time.
Good luck hope this helps.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 13 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

About Us

Follow Retrobike

Other cool stuff

All content © 2005-2015 Retrobike unless otherwise stated.
Cookies Policy.
bikedeals - the best bike deals in one place
FatCOGS - Fat Chance Owner's Group

Powered by phpBB® Forum Software © phpBB Group