My partners bike, a 2000ish Rockhopper FSR is running an E-Type front de. Only thing is that the E-type screw stub on the frame has been ground off. I have rectified this by getting a DMR chain device bit.
It works ok, but I can't get the E-type de to work 100% with this setup.
Does anyone know if a M953 High mount top pull front de would work?
Plus would this front de work on an M950 8speed setup?
Bike is same type frame as this:
This is the DMR thing I use minus the wheel to attach the e-type front de:
This is what i want to run?
M95* Mid/Short cage rear mech
M95* Rear shifter 8 or 9 speed
90mm Ringle Zooka