Retrobike
http://www.retrobike.co.uk/forum/

axiom front hubs
http://www.retrobike.co.uk/forum/viewtopic.php?f=41&t=141524
Page 1 of 2

Author:  cyfa2809 [ Thu Mar 17, 2011 1:20 am ]
Post subject:  axiom front hubs

i have the chance to buy a wheel with this hub

http://www.pinkbike.com/buysell/689988/

but would need to convert it to 9mm qr
is it possible?
i have seen the adapters but didnt realise they werent universal?

Author:  dirtydozen [ Thu Mar 17, 2011 4:01 pm ]
Post subject: 

i have same hub on my giant. I was looking into the adapters myself before getting the boxxers, but snap didnt realise they werent uni. Nice smooth hub though

Author:  cyfa2809 [ Thu Mar 17, 2011 4:45 pm ]
Post subject: 

i know there are hope ones
and nuke proof ones ( i guess thay make hubs now?/always have?)

i read they were wider then qr, 110 instead of 100? :? :?
not sure
would be ideal if i could though

Author:  dirtydozen [ Thu Mar 17, 2011 6:49 pm ]
Post subject: 

wud any mesurements off mine help?

Author:  FMJ [ Thu Mar 17, 2011 7:22 pm ]
Post subject: 

Axiom is Norco's Taiwanese "house brand" label. They spec it on all their low to midrange bikes. We lovingly refer to it as fromage around these parts. The question is, would you spend $+shipping then do an axle swap on an Exage hub, because that's about the equivalent.

Author:  cyfa2809 [ Thu Mar 17, 2011 7:26 pm ]
Post subject: 

dd yes please 8) could help


and fmj, that hub/ad is just for reference :wink:
didnt want to link the actual one in case someone jumps on it :(

Author:  dirtydozen [ Thu Mar 17, 2011 8:20 pm ]
Post subject: 

what measurements you want

Author:  cyfa2809 [ Thu Mar 17, 2011 8:20 pm ]
Post subject: 

width
and any others you would deem necessary?

Author:  dirtydozen [ Thu Mar 17, 2011 8:22 pm ]
Post subject: 

NP will bob in garage later

Author:  cyfa2809 [ Thu Mar 17, 2011 8:24 pm ]
Post subject: 

thanks 8)

Page 1 of 2 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/