Yea I did think and have just had a quick look this morning and I'm not sure by spacing the rotors out will cause any issue with the caliper... I think it would be damm close..
I really dont want to have to file off part of the tabs on the disc not only because I should not have too ,, but also I'm slightly worried that once removing the require material from the rotor , if in fact it would then be safe and more importantly , if I'd feel safe putting my trust in them..
I know its only roughly matbe 1-2mm I might need to file,, but there's not much meat on the tabs to start with..
I dunno real strange one,,, I've asked the seller if he knew what model of hub they were and , unfortunately he did'nt..
So Ideally it would be nice if someone on here could Identify the model of the hub.. (Wu... do you know.. ? )
Once I've got the model number , maybe then I could drop DT a email asking if there is any special adaptors needed,, or if they are only compatible with certain rotors,,
Bit annoyed there as I've just bought two brand new Ashima rotors and really wanna use these ...
The Avid rotor you've got fella, , I'd really appreciate if you'd zip it over for me to try at least, as it seems a little silly buying a avid rotor to try...
I'll sort the postage costs out no problem fella..
drop us a pm if you would chap..
Another question is :
I had a quick look but came up zilch... I wondered if there was a website with all the id and od specs on different manufactures rotors.. ? .. ?