so I'm building the other half a bike and all I need now is a seat post and clamp to finish it
the verniers put the outer diameter or the down tube at 35mm and the internal at 30.2mm
so I figure I need a 30.1mm seat post and a 34.9mm clamp? the seat post from my Norco is 30mm and that falls into the the tube and rattles around! yet if I use the clamp from the Norco, that fits ok, but I really have to tighten it up and can see the tube deforming!
so would you agree with my sizeing? as these are regular size bits that are available at all good LBS's and online shops