These are my spare set that I was keeping just in case something went wrong with the RC39 C-Types that I run on the RC300 but need the money for something else
100mm travel with 1 1/8 steerer tube that is 183mm long, handlebar mounted lock out, International Standard disc mounts and inserts for V-brake bosses but I don't have bosses for them, no star nut fitted. Same basic design as all new DT Swiss forks.
A full service was carried out on them last year by Fork English which included strip down & rebuild with new oil, garter seals, cartridge seals, bearing kit and pressure test at a cost of £105, they have not been used since.
There is a small amount of wear to the anodising on the right stanchion but this doesn't affect function. The white mark on the left stanchion in the picture is just polystyrene, not a chip, didn't notice it when I took the picture. :roll:
A set of these in similar condition just went for £230 plus P&P on fleaBay, I'm looking for £200 plus P&P.
Payment by either Paypal buyer to pay fees, bank transfer or cash on collection.
100mm travel with 1 1/8 steerer tube that is 183mm long, handlebar mounted lock out, International Standard disc mounts and inserts for V-brake bosses but I don't have bosses for them, no star nut fitted. Same basic design as all new DT Swiss forks.
A full service was carried out on them last year by Fork English which included strip down & rebuild with new oil, garter seals, cartridge seals, bearing kit and pressure test at a cost of £105, they have not been used since.
There is a small amount of wear to the anodising on the right stanchion but this doesn't affect function. The white mark on the left stanchion in the picture is just polystyrene, not a chip, didn't notice it when I took the picture. :roll:
A set of these in similar condition just went for £230 plus P&P on fleaBay, I'm looking for £200 plus P&P.
Payment by either Paypal buyer to pay fees, bank transfer or cash on collection.