Hope bottom bracket tool **SORTED - BUT HAVE A LOOK!!

Konsta

Retro Guru
Hello everyone!

Desperately looking for bottom bracket tool to use with my Hope bb.

Need this. Hope bb tool:
HTT204G.jpg


...or this. Royce bb tool:
20496_124110.jpg



If you such a tool, please PM!
 
Re: Hope/Royce bottom bracket tool very needed!

Well, in the bb cup the holes are in a 29 mm diameter circle (about).

The holes themselves have a 3.3 mm diameter.
 
Re: Hope/Royce bottom bracket tool very needed!

If you can get me accurate measurements I will make you one for a few pounds.
By accurate measurement I mean vernier calipers or better, not a tape measure, measuring jug, ruler, 'a good guess' or the odometer in your car!

:p
 
Re: Hope/Royce bottom bracket tool very needed!

Rampage, if you can make them, I think you'll sell a few here; I'd 100% take one.

I'll get measurements later tonight.
 
Re: Hope/Royce bottom bracket tool very needed!

My_Teenage_Self":37r1ov4j said:
Rampage, if you can make them, I think you'll sell a few here; I'd 100% take one.


+1

bear me in mind if you ever go down this road
 
Re: Hope/Royce bottom bracket tool very needed!

I don't mean to sound rude, but I will explain a good way to measure the distance between the holes, centre - centre:

Measure the diameter of one of the holes (check they are all the same size first) then reset the calipers at the size indicated. Then measure (only for an even number of holes such as these) the distance between opposite holes using the far edge of the holes you are measuring, not the centre. The measurement indicated is the centre-centre measurement of the holes.

Also hole depth please :)
 
Back
Top