TVT Greg Lemond and brake lever/delta set up

When I need to do anything to my Deltas, I run a new cable through with a tyreless rim in place. Squeeze the Brake pads to where I want them, with the other hand tug the cable tight, Tighten the 3.5mm alan bolt, snip cable off flush with bottom, (or slightly higher if you have small wire cutters). Never failed, they work beautifully. I've only ever set them up onto Ergos though, not used the older brake only levers.
 
Re:

Thanks Big Foz,

I will have a go using that method over Christmas. I set up the Deltas on another bike with Ergolevers and it worked fine. I was never really happy with how they turned out on this bike, the brake lever action is very stiff, that could be how the cable has to turn over the little insert plate in the brake levers. it would be worth another go.

Regards,

Pat
 
Back
Top