richiehops
Dirt Disciple
Started Building the Kona Humu Humu project this afternoon.
Homemade headset press worked a treat. cost £4
Going to get a BB and fit tomorrow. Can anyone shed any light on how to ensure I get the right length square taper bb for a single speed set up. Will be fitting 3 ring truvative crank but with one ring and will use spacer kit on 10 speed rear hub wth single cog.
With out a bb fited it's hard to estimate and measure the distance. Have looked at sheldon brownsdata base, still a bit confused.
Thinking 118mm bb would be a good middle ground for chainring clearance, chain line can e adjusted with spacers on rear wheel.
Homemade headset press worked a treat. cost £4
Going to get a BB and fit tomorrow. Can anyone shed any light on how to ensure I get the right length square taper bb for a single speed set up. Will be fitting 3 ring truvative crank but with one ring and will use spacer kit on 10 speed rear hub wth single cog.
With out a bb fited it's hard to estimate and measure the distance. Have looked at sheldon brownsdata base, still a bit confused.
Thinking 118mm bb would be a good middle ground for chainring clearance, chain line can e adjusted with spacers on rear wheel.
