rusty bodie
Senior Retro Guru
- Feedback
- View
I am using a DA 9 speed set up on my old TVT and the gear shift
into the smaller cogs has always been really hesitant. It works fine on the the work stand but on the road it rattles and doesn't go into the 14t and 12t cleanly at all. I have messed about with the cable tension no end and the outer casing into the rear mech to no avail either. When the cable is detached, the mech won't even reach the 12t cleanly and that's with the limit screw adjusted right out.
I'm using a 7703 chainset, BB, DA 7700-9S downtube shifters and DA 9 speed titanium cassette. The rear mech says DA 7700 and that's apparently the 9 speed mech for the job. Everything is in NOS/ VGC so wear isn't an issue here.
Any ideas chaps because I am stumped!! :|
Many thanks.
Craig
into the smaller cogs has always been really hesitant. It works fine on the the work stand but on the road it rattles and doesn't go into the 14t and 12t cleanly at all. I have messed about with the cable tension no end and the outer casing into the rear mech to no avail either. When the cable is detached, the mech won't even reach the 12t cleanly and that's with the limit screw adjusted right out.
I'm using a 7703 chainset, BB, DA 7700-9S downtube shifters and DA 9 speed titanium cassette. The rear mech says DA 7700 and that's apparently the 9 speed mech for the job. Everything is in NOS/ VGC so wear isn't an issue here.
Any ideas chaps because I am stumped!! :|
Many thanks.
Craig