D
Deleted member 24574
Well I have an axel which has a messy thread than needs a bit of re-cutting to clean it up. I suspect caused by overzelous tighening of the lock nut onto the cone at some point.
After much fidding with dies I guessed it was a M10 x 1.0 which we dont have, so I ordered one ... and it dosn't fit :evil:
Anyone know the spec of the thread, is it standard?
After much fidding with dies I guessed it was a M10 x 1.0 which we dont have, so I ordered one ... and it dosn't fit :evil:
Anyone know the spec of the thread, is it standard?
