Is there any way to do this without removing the anodizing? I recently bought a set of NOS hubs, but there are some small marks on them.
What's the best thing to use to try and clean them? If it doesn't work I'm not too worried as the marks are small and only visible from very close - I'd prefer to keep the marks and the anodising than sand them down to bare metal.
Thanks!
What's the best thing to use to try and clean them? If it doesn't work I'm not too worried as the marks are small and only visible from very close - I'd prefer to keep the marks and the anodising than sand them down to bare metal.
Thanks!