Morning all,
I'm trying to fit a rear screw on freewheel 130mm campag hub to a frame with 126mm width, the frame does spring a bit to allow the hub to fit but the middle of the rim is off centre to the left. Is it best to reduce the spacing or just redish the wheel or both?
Im surprised the hub is 130mm as it's a screw on block and from late 80's early 90's
Any advice appreciated especially re best way to respace hub.
Thanks
I'm trying to fit a rear screw on freewheel 130mm campag hub to a frame with 126mm width, the frame does spring a bit to allow the hub to fit but the middle of the rim is off centre to the left. Is it best to reduce the spacing or just redish the wheel or both?
Im surprised the hub is 130mm as it's a screw on block and from late 80's early 90's
Any advice appreciated especially re best way to respace hub.
Thanks