Shimano 600 calipers

xzaar

Retro Newbie
Hi

Im trying to install this shimano 600 brake calipers and im really struggling setting the wire in its place. it alwais get loose from the caliper. Should it be like in the picture? in some other way?

thanks
 

Attachments

  • WhatsApp Image 2018-09-20 at 17.50.57 (2).jpeg
    WhatsApp Image 2018-09-20 at 17.50.57 (2).jpeg
    154 KB · Views: 372
  • WhatsApp Image 2018-09-20 at 17.50.57 (1).jpeg
    WhatsApp Image 2018-09-20 at 17.50.57 (1).jpeg
    112 KB · Views: 372
  • WhatsApp Image 2018-09-20 at 17.50.57 (1)2.jpg
    WhatsApp Image 2018-09-20 at 17.50.57 (1)2.jpg
    121.2 KB · Views: 370
Re:

I have two sets of Shimano 600 (Arabesque and the latter mid 80's version) and I believe they both have a hole in the center of the bolt that the brake cable should slide into before tightening. Take a closer look at the bolt and move it around a bit to see if the hole moves into view.
 
Spin the rear washer round until the two tabs lock either side of the caliper... I think, been a long time lol
 
Re:

xzaar":1qvzd8b5 said:
You are f***ing right mate. I have waste all day fighting with it. Thanks

:)

Hey, those modern cartridge brake pads look pretty sweet there. I may have to try some of those on my retro roadies. Then I can run salmon koolstop pads.
 
Back
Top