Campagnolo Gran Sport RD stop pin replacement

trail-blazer

Retro Guru
The screw/stop which stops the cage rotating too far on my rear mech was bent. I had to cut it, to remove it,
(too bent to screw out) but it is out now so I'm looking for something similar to replace it with.

It has an M5 thread and a 6mm diameter flat screw head. The lower part is unthreaded and the screw appears to have been chemically blackened. It's, roughly, 20mm long including the head.

I'm sure this would have been a common problem, due to the screw/stop being so flimsy, so someone must have had to this.

Excuse the poor terminology. :facepalm:

Can put up pictures if needed...
 
Back
Top