Project 2 question?

mikeoftherose · May 27, 2009

Got a question I need answering as Im not that technical, I am restoring my early 95 explosif & want to put a pair of the original project 2's back on but want the tripple butted ones with canti studs & to be suitable for an aheadset rather than threaded with a quil stem is this possible?

• Tripple butted (lightweight)
• Canti Studs
• Non threaded (Aheadset compatible)

If anyone out there has what Im after then give me a shout with what you want for them please.....

Cheers

orange71 · May 27, 2009

you might want to stick this in Wanted section

mikeoftherose · May 27, 2009

thanks orange71

thanks orange71

JeRkY · May 27, 2009

Should be possible, but could be hard.

Depending on the frame size you could try looking out for a threaded set for a large (21" ish ) frame, then cut them short to use on a smaller frame with A-head...you would need to measure up properly obviously.

Project 2 question?

mikeoftherose

Retro Newbie

orange71

mikeoftherose

Retro Newbie

JeRkY

Similar threads

Latest posts