Hi, bit of a fettling going on at my house today. 952 front mech with non-parallel plates... which plate do I line up with the chainrings outer or inner?
I think it should be the outer plate but I just can't get the indexing right....
perhaps I'm holding my mouth wrong?
(For the fuller picture running a Middleburn RS7 with hardcote slickshift rings. Problem I keep getting is middle ring keeps rubbing on inner plate when chain on outer ring. I've set the front mech to 3mm above the top of the teeth (which I know are slightly shorter than big s teeth. Should I increase this to 4mm?)
Scratches head, goes to make cup of tea...
Why do I ride a Pace - it's all that bl**dy sheep's fault