Bullseye Crank Help

GearlessinSeattle

Senior Retro Guru
Okay, so these came on my Klein Attitude that I just picked up.
There was a little play in the cranks and it looks like there needs to be a couple of more spacers on the axel.
Questions is:
What size spacers and where to buy?
Thanks
 

Attachments

  • IMG_0425_1.JPG
    IMG_0425_1.JPG
    36.7 KB · Views: 612
  • IMG_0423_1.JPG
    IMG_0423_1.JPG
    94.1 KB · Views: 612
hi
i ran bullseye cranks for a few years. the reason i stopped using them was the play in the BB.

the modern conversion kit might make them better, i haven't tried it with mine yet.

check the BB bearings and i'm sure you'll find that they move a lot
 
I got rid of most of my spacers. I found an old seat post which had an internal diameter that was a pretty tight fit over the axle and just cut it to size. The Bullseye cranks are meant to have a bit of play in them which creates a love/ hate relationship with owners.
 
Pretty sure 23mm ID, or M22 washers will do the job. They have a much bigger OD than the original ones, but they do the job. Ebay sells 'em
 
Back
Top