Onza Ti Bar Ends

Smithjss70 · Jun 9, 2016

I stumbled across some Onza titanium bar ends in one of my bins and brought them back to a lustrous shine with some scotchbrite pads. I've misplaced the bolts and the boots are long since deteriorated but was wandering if anyone knows the correct size length/diameter bolt that they need. Am hoping to find some new Ti bolts to use with them. Thanks!

player · Jun 10, 2016

Re:

I've got a couple of pairs and can have a look tomorrow when I get back home.

Or look here.

http://www.bikepro.com/arch_products/barends/onza.html

Smithjss70 · Jun 11, 2016

Re: Re:

player":x41hmk6x said:
I've got a couple of pairs and can have a look tomorrow when I get back home.

Or look here.

http://www.bikepro.com/arch_products/barends/onza.html

Thanks Player. I went there first, took this info and ordered some Ti screws with these measurements but the diameter isn't correct (too small). FROM BIKEPro "The bolt has a 6mm allen head fitting with 6mm x 1mm thread pitch, 20mm long weighing 6 grams".

The clamp hole is bigger than this reported measurement or at least mine are. Seldom have I seen misinformation on that site and I still may be missing something on my end but don't think so.

Rampage · Jun 12, 2016

Re:

Have you got a picture?
6mm Allen head bolts are usually M8 but I have seen barends with M6 bolts that take a 6mm Allen key.

player · Jun 12, 2016

Re:

Both my sets have 5mm allen key key heads and both thread lengths are 17mm.

Smithjss70 · Jun 12, 2016

Re:

Thanks man! Much appreciated.

Onza Ti Bar Ends

Smithjss70

player

Smithjss70

Rampage

player

Smithjss70

Similar threads

Latest posts