This crank spider original ?
- Thread starter dyna-ti
- Start date
The cranks are Cro Magnon cyclone , its the spider that doesnt match up, and it was that i was wondering about.
I think youre thinking of the reverse of L&M, with its cncing there.
Was intending as a wee polish project ,maybe even find someone willing to put a bit of colour into them.....
Hopefully arrive tomorrow or early next week and i can get a look of the reverse and post a pic.
I think youre thinking of the reverse of L&M, with its cncing there.
Was intending as a wee polish project ,maybe even find someone willing to put a bit of colour into them.....
Hopefully arrive tomorrow or early next week and i can get a look of the reverse and post a pic.
Re:
I'd suggest perhaps not original, have you seen the thread in the link below? the Cyclone cranks in that thread have a spider which looks to be stepped or dished.
http://www.retrobike.co.uk/forum/viewto ... ;start=150
I'd suggest perhaps not original, have you seen the thread in the link below? the Cyclone cranks in that thread have a spider which looks to be stepped or dished.
http://www.retrobike.co.uk/forum/viewto ... ;start=150
I looked at those previously Jim, and it was the different spider made me go of it.
I know theyre mtb, but i cannot say 100% that theres not a range of spiders, given these are 130mm bcd,which suggests road. But these are beefy and i wouldnt think a roadie would use such a heavy bit of kit.
Reverse looks too exact to be anything other though and its totally flat.
Only provision for a single outer and a (looks like)74mm bcd inner
I know theyre mtb, but i cannot say 100% that theres not a range of spiders, given these are 130mm bcd,which suggests road. But these are beefy and i wouldnt think a roadie would use such a heavy bit of kit.
Reverse looks too exact to be anything other though and its totally flat.
Only provision for a single outer and a (looks like)74mm bcd inner
