Just repainted my Technium. I had to burn out the old bb but I ruined the cable guide in the process.
How should I fix on new cable guide? I don't have rivet gun. Fixing Hole is about 5mm in diameter. Shell is steel. Must be v. shallow to give sufficient clearance to bb.
OK I'm going to try and pop-rivet back on if I can borrow rivet gun from mate at work. Originally it was riveted on.
Annoyingly I bought a replacement and now can't find it; they're only a couple of quid but even so, grrr.
If all else fails I might try double-sided tape; any recommendations for 'good' tape? I've got some nasty pound shop stuff but I don't think I trust it...
Don't really fancy the glue route as I haven't had a lot of luck with stuff I've epoxied recently. Must be losing my touch!
I'm waiting for payday to come so I can buy some for a non-bike project.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.