Help with hope No2 torque arm installation

Timoth27

Senior Retro Guru
Hi all,

Just looking for a bit of help, I acquired the above with a hope wheel set a while back and only now getting round to trying to fit it. So I think I have a bulb hub (5bolt spider) but It doesn’t have a nds end cap. However it seems to fit in the frame (with the Caliper fitted obviously) fine but the rim is not central in the frame, it’s roughly 5mm over to the nds. I have another bike with an is torque arm and xc hub which I thought I could swap around unfortunately it appears to be slightly different so any thoughts???

Thanks

Tim.
 
Re:

Wheel just needs redished. Not unusual with wheels built for a different frame, especially with adapters.
Loosen nds spokes by half turn then tighten ds by half turn. Repeat until wheel centred.
 

Latest posts

Back
Top