Hi Tomskid27,
see my post on the previous page. Hopefully you have a "new" hub from somewhere, and need to get the ratchet ring in the hub screwed in a little further.
The freehub body (with the pawls) pushes/presses on, and can only seat as far as the bearings meeting their shoulders on the axle. No further. The shoulder set the maximum position if you like.
However, the ratchet ring in the hub that the pawls locate into, is screwed into the hub shell, and I have seen a couple of instances of this not being screwed in far enough, and dragging slightly on the freehub body, and standing it off its shoulders.
Get the ratchet ring all screwed down as far as it will go by standing on the pedals of the drivetrain, andyou should be good to go (asain, as per the post on the previous page).